Invacare G40 Service Manual page 25

Disassembly Brake disc
• Disassemble front wheel. See also chapter 8.2.
• Remove brake caliper (5) from mounting (12). See above.
• Remove nut (18) and disc and take off wheel hub (19) with brake disc from axle.
• Release four countersunk screws (M6 with hexagon) and take off brake disc (14) from hub.
Assembly
• Assembly is carried out in reverse order..
Disassembly brake straps and bowden wire
• Release wing screw (1) and take off brake lever (2).
• Remove chassis covering. See chapter 8.1.
• Disassemble brake calipers (5) (at both front wheels). See above.
• Remove cap (23) and release nut (22) until you can draw the bowden wires (6) out of the holder (4).
• Remove starlock caps (21) with a screwdriver (dislever) and take off discs (24).
• Take off brake straps (3) with sockets (20) from chassis and take apart bowden wires (6) from brake straps.
If necessary pinch up the caps of bowden wires.
• Disassemble bowden wires (6) with bowden wire sleeves (8) from chassis.
Assembly
• Assembly is carried out in reverse order.
NOTE:
• During assembly new starlock caps must be used.
• For assembling of caps see chapter 7.3,
assembly of starlock caps at backrest.
NOTE:
• Do not forget roundmagnet and socket.
25