Table of Contents
Advertisement
Edison Installation and Operation Manual
PART A – INSTALLATION
2 Installation Safety Information
2.1 Installation Warnings, Cautions and Recommendations
• PROFESSIONNAL INSTALLATION IS HIGHLY RECOMMENDED.
• YOU MAY NEED TO OBTAIN A BUILDING PERMIT FOR THE INSTALLATION OF
THIS STOVE AND ITS VENTING SYSTEM. CONSULT YOUR MUNICIPAL
BUILDING DEPARTMENT OR FIRE DEPARTMENT BEFORE INSTALLATION TO
DETERMINE THE NEED TO OBTAIN ONE. WE RECOMMEND THAT YOU ALSO
INFORM YOUR HOME INSURANCE COMPANY TO FIND OUT IF THE
INSTALLATION WILL AFFECT YOUR POLICY.
• THIS STOVE MUST BE CONNECTED TO A STANDARD GROUNDED ELECTRICAL
OUTLET FROM 88 TO 264V AC AND FROM 47 TO 63 HZ. DO NOT USE AN
ADAPTER PLUG OR SEVER THE GROUNDING PLUG. DO NOT ROUTE THE
ELECTRICAL CORD UNDERNEATH, IN FRONT OR OVER THE STOVE.
• THIS STOVE CAN BE PLUGGED TO A 24 TO 30V BATTERY SYSTEM (MINIMUM
20Ah) AND ABSOLUTLY NEEDS TO USE THE ANDERSON SB50® CONNECTOR.
IF YOU INSTALL THE BATTERY BEHIND THE STOVE USING THE OPTIONAL
BATTERY HOLDER KIT (AC01452), THE BATTERIES MUST BE SEALED.
• IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT.
TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS.
• BURNING ANY SOLID FUELS GENERATES CARBON MONOXIDE IN LOW
CONCENTRATION. THIS GAS IS EVACUATED BY THE VENTING SYSTEM. IN
HIGHER CONCENTRATIONS, CARBON MONOXIDE IS TOXIC AND MAY CAUSE
DEATH. TO PREVENT THIS, ENSURE THAT YOUR VENTING SYSTEM IS
AIRTIGHT.
• THIS STOVE IS MOBILE HOME APPROVED AND REQUIRES INSTALLATION OF
A FRESH AIR KIT, SOLD SEPARATELY. THE STOVE MUST BE ATTACHED TO
THE STRUCTURE OF THE MOBILE HOME AND THE STRUCTURAL INTEGRITY
OF THE MOBILE HOME FLOOR, WALL, AND CEILING/ROOF MUST BE
MAINTAINED. DO NOT INSTALL IN A SLEEPING ROOM.
• THIS STOVE IS NOT RECOMMENDED TO BE INSTALLED IN A BEDROOM OF
CONVENTIONAL HOUSES.
• THIS STOVE HAS BEEN DEVELOPED AND BUILT FOR RESIDENTIAL
SUPPLEMENTARY HEAT SOURCE. COMMERCIAL AND INDUSTRIAL USE IS
PROHIBITED AND WILL VOID THE WARRANTY.
9
Advertisement
Table of Contents
