Installation Configurations; Installation Warnings, Cautions And Recommendations Reminder - Drolet Edison Installation And Operation Manual

Table of Contents

Edison Installation and Operation Manual

United States:

• Not Less than 36'' (91 cm) above any forced air inlet located within 10 feet (305 cm);

• Not Less than 48'' (122 cm) below and horizontally from, or one foot (30 cm) above,

any door, window or gravity air inlet into any building (See Section 4.4.1.1: Direct

Vent System (2-in-1 Exhaust and fresh air intake);

• Not Less than 24'' (61 cm) from an adjacent building and not less than 84'' (213 cm)

above grade when located adjacent to a public walkway.

• Cannot be located less than 12 inches (300mm) above grade.

• Cannot be located above a gas meter/regulator within 3 feet (900mm) horizontally of

the vertical center line of the regulator.

• Not within 6 feet (1.8 meters) of a gas service regulator vent outlet.

• Other restrictions may apply. See NFPA 211 for further information.

4.4.1.1

Direct Vent System (2-in-1 Exhaust and fresh air intake)

When the stove is installed with a direct vent system, the exit terminal shall be located at

least 9" (23 cm) away from a window or door.

The bottom of the exhaust terminal and air intake must be located at least 1" (30 cm)

above the ground.

4.5 Installation Configurations

• PROFESSIONNAL INSTALLATION IS HIGHLY RECOMMENDED

• THIS STOVE USES A PRESSURIZED VENTING SYSTEM. ALL VENT CONNECTOR

JOINTS MUST BE SEALED AND FASTENED. YOU MAY USE RTV SILICONE

(ROOM TEMPERATURE VULCANISATION), METALLIC TAPE, AND A MINIMUM

OF THREE SELF-TAPING SCREWS AT ALL JOINT CONNECTIONS TO ENSURE A

TIGHT SEAL. CONSULT THE PELLET VENT MANUFACTURER'S INSTRUCTION

TO ENSURE PROPER INSTALLATION, CONSISTENT PERFORMANCE, AND TO

AVOID SMOKE AND ASH SPILLAGE.

• THE CHIMNEY CONNECTOR SHALL NOT PASS THROUGH AN ATTIC OR ROOF

SPACE, CLOSET OR SIMILAR CONCEALED SPACE OR FLOORS OR CEILING.

• INSTALL VENTING SYSTEM AT CLEARANCES SPECIFIED BY THE VENT

MANUFACTURER.

• THE USE OF A SPARK ARRESTER AT THE END OF THE TERMINATION IS

MANDATORY. IT IS IMPORTANT THAT THE SPARK ARRESTER BE CLEAR OF

ANY DEBRIS AT ALL TIME.

Table of Contents

Dp00065