Backup Light - Subaru 2016 Outback Owner's Manual

Hide thumbs Also See for 2016 Outback:
Table of Contents

Advertisement

1)
Rear turn signal light
2)
Rear side marker light
5. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
6. Pull the bulb out of the bulb holder and
replace it with a new one.
7. Set the bulb holder into the rear
combination light assembly and turn it
clockwise until it locks.
8. Reinstall the rear combination light
assembly by sliding the two-pronged part
of the combination light assembly securely
to each holder of the vehicle side.
9. Tighten the upper and lower screws.
10. Reinstall the side cover.
Maintenance and service/Replacing bulbs
& Backup light
! Legacy
NOTE
It may be difficult to replace the bulbs.
We recommend that you have the bulbs
replaced by your SUBARU dealer if
necessary.
1. Open the trunk.
2. Remove the trunk trim lining by re-
moving the clips indicated in the illustra-
tion.
11-45
– CONTINUED –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2016 legacy

Table of Contents