Subaru 2016 Outback Owner's Manual page 192

! Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
! Welcome Screen
The welcome screen can be activated or
deactivated. Select "On (with Sound)" to
activate the screen and sound. Select "On
(without Sound)" to activate the screen
and deactivate the sound. Select "Off" to
deactivate the screen.
! Good-bye Screen
The Good-bye screen can be activated or
deactivated. Select "On" to activate the
screen. Select "Off" to deactivate the
screen.
! Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the "ON"
position can be activated or deactivated.
Select "On" to activate. Select "Off" to
deactivate.
! Gear Position Indicator Settings
(MT models)
The gear position indicator light can be
activated or deactivated. Select "On" to
activate. Select "Off" to deactivate.
! Units
You can select the displayed units of the
distance, vehicle speed and volume.
Operate the " " or " " switch on the
steering wheel to display the preferred
units. Then pull the " /SET" switch to
select the displayed units.
! Languages
Operate the " " or " " switch on the
steering wheel to display the preferred
language. Then pull the " /SET" switch to
select the displayed language.
! Combination Meter Illumination (if
equipped)
After entering the "Combination Meter
Illumination" menu, select the following
menu.
! Meter Ring Illumination
The illumination of the combination meter
rings can be activated or deactivated.
Select "On" to activate the illumination.
Select "Off" to deactivate the illumination.
! EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner's Manual supple-
ment for the EyeSight system.
Instruments and controls/Multi information display
After entering the "EyeSight" menu, select
one of the following menus.
! Warning Volume
The volume of the warning buzzer that
sounds when the EyeSight system is in
use can be set in 3 stages ("Max", "Mid"
and "Min").
! Lead Vehicle Acquisition Sound
When adaptive cruise control is used, the
buzzer that sounds under any of the
following conditions can be activated or
deactivated.
. A vehicle is detected in front
. Detection is not possible
Select "On" to activate the buzzer. Select
"Off" to deactivate the buzzer.
! Lead Vehicle Moving Monitor
Function
When adaptive cruise control is used, the
buzzer that sounds if a vehicle in front has
started can be activated or deactivated.
Select "On" to activate the buzzer. Select
"Off" to deactivate the buzzer.
! Vehicle Icon
The vehicle icon indication can be acti-
vated or deactivated. Select "On" to
activate. Select "Off" to deactivate.
3-41
– CONTINUED –