1-1] Slot-Ip-Extension Port - Panasonic KX-TDA50 Programming Manual

Voice (RTP) UDP Port No. (IP-PT)
Specifies the UDP port used to transmit and receive RTP (Realtime Transfer Protocol) data on the IP-
PT side. This must be changed if another network application is using the same port.
For voice communications, an IP-PT uses 64 (with the IP-EXT16 card) or 16 (with the IP-EXT4 card)
contiguous UDP ports, starting from the port number specified here.
Default
8000
Value Range
1024–65472
Maintenance Console Location
2.7.23 [1-1] Slot—IP-Extension Card Property—Common Settings
Programming Manual References
None
Feature Manual References
1.9.15 IP-PT (IP Proprietary Telephone)
2.7.24 [1-1] Slot—IP-Extension Port
Various settings can be programmed for each IP extension port.
To change the status of extension ports, click Command.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming both the PBX and IP-PT before it can be
used. Programming instructions of the PBX are given below.
It is possible to de-register the IP-PT later.
Preparation
Follow the steps below to prepare before registering an IP-PT.
1.
Open 2.7.22 [1-1] Slot—IP-Extension Card Property, and confirm that the IP address and
subnet mask settings of the IP-EXT card are correct.
2.
Open 2.7.23 [1-1] Slot—IP-Extension Card Property—Common Settings and set the
gateway address.
Registration
Follow the steps below to register the IP-PT.
1.
Connect the IP-PT to be registered to the network and, if necessary, the power supply.
2.
Click Registration.
A dialog box will appear. Non-registered (available) extension numbers are displayed on the
left.
2.7 [1] Configuration
PC Programming Manual 193