Glide-Out Grill; Control Panel And Doors - Rangemaster Elise 110 Induction User's Manual & Installation Instructions

Glide-out Grill

The grill pan and trivet should be washed in hot soapy water.
Alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the trivet using a nylon brush.
Before you remove any of the grill parts for cleaning,
n n
make sure that they are cool, or use oven gloves.
The grill pan can be easily removed for cleaning as follows:
Remove the grill pan support frame by pulling the grill pan
forward (Fig.5-2).
Lift the grill pan clear of the support frame. The support frame
is held to the side rails by two clips on each side (Fig.5-3).
For each side, support the side rail with one hand and with
the other hand lift the frame up and out of the side clips
(Fig.5-4).
For safety, push the side rails back into the grill chamber.
If you need to remove the side rails to allow cleaning of the
grill chamber, you can unhook them from the grill chamber
sides (Fig.5-5) and wipe the sides clean with a soft cloth and
mild detergent.
DO NOT use any abrasive substances.
n n
DO NOT put the side runners in a dishwasher.
n n
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, make sure that the wide rim is at
the front (Fig.5-6).

Control Panel and Doors

Avoid using any abrasive cleaners, including cream cleaners.
For best results, use a liquid detergent.
The same cleaner can also be used on the doors. Alternatively,
use a soft cloth wrung out in clean hot soapy water. You can
use the same method for cleaning the control panel and
knobs.
After cleaning, polish with a dry cloth.
Removing the Panels to Clean the Enamel
Interior
If you wish to clean the enamel interior of the oven, you will
need to remove the shelves before removing the panels.
You do not have to remove the support brackets to remove
the panels. Lift each panel upward and slide forward off the
support brackets (Fig.5-7).
Once the panels have been removed, the oven enamel
interior can be cleaned.
DO NOT use steel wool, oven cleaning pads, or any
n n
other materials that will scratch the surface.
Refit in the reverse order.
ArtNo.331-0003 Grill frame out, no pan
ArtNo.331-0004 Removing the grill frame
ArtNo.331-0005 Removing the grill rail
16
ArtNo.331-0006 Grill pan plan
Fig. 5.3
Fig. 5.4
Fig. 5.5
Fig. 5.6
Fig. 5.7