Table of Contents
Advertisement
Top End® Sports Series
Schulte 7000/T-5™ 7000 Front Fork and Anti-Tip Fork Stem
Assembly Replacement
The Front Fork and Anti-Tip Fork Stem Assembly parts may
be purchased separately.
1.
Place the empty wheelchair upside down so the bottom of the
front fork is easily accessible.
Loosen and remove the bolt A, split lock washer (not shown),
2.
headtube cap B, and anti-tip headtube C from the anti-tip fork
assembly D.
Loosen and remove the chainring bolt E and washer F from
3.
the anti-tip fork assembly D.
4.
Remove the headtube bushing and dowl pin assembly G and fork
stem H from the anti-tip fork assembly D.
Install the new headtube bushing and dowl pin assembly G and
5.
fork stem H into the anti-tip fork assembly D.
Insert chainring bolt E and washer F and tighten securely.
6.
Install new bolt A, split lock washer (not shown), headtube cap
7.
B, and anti-tip headtube C. Tighten securely.
48
5.13 Adjusting Seat Height for Top End Pro
Tennis, Top End Pro BB, and Top End Pro-2™
All Sport
WARNING!
RISK OF INJURY OR DAMAGE
– After any adjustments, repair or service and before
use, make sure all attaching hardware is tightened
securely. Otherwise injury or damage may occur.
Adjusting Front/Rear Seat Height
Remove the mounting screws A, (washer D if applicable) and
1.
locknuts B that secure the height adjustment brackets C to
the base frame .
2.
Perform one of the following:
•
Adjust rear of seat to desired height.
•
Adjust front of seat to desired height.
3.
Secure height adjustment brackets C to the base frame with the
two mounting screws A and locknuts B. Tighten securely.
Refer to images on next page.
1171910-A~15
Advertisement
Table of Contents
