Service; Removing/Installing Rear Wheels - Invacare Top End T-5 7000 Series User Manual

Top End® Sports Series

6 Service

6.1 Removing/Installing Rear Wheels

CAUTION!
– Changing the size of the rear wheels can affect the
performance of the wheelchair. Contact Invacare at
the telephone numbers on the back of this manual
before changing rear wheel size.
1. Perform one of the following:
•
Quick-release - push in the tip of the quick-release axle A
and pull axle and wheel B away from the wheelchair C.
•
Quad-release - Lift up on the handle of the quad-release axle
A and pull axle and wheel B away from the wheelchair C.
Repeat STEP 1 for the opposite rear wheel B.
2.
Install the rear wheel wheels B onto the wheelchair C by
3.
reversing STEPS 1-2.
WARNING!
RISK OF INJURY OR DAMAGE
– Pull on the rear wheel B to make sure the
detent pin D and locking pins E of the
quick/quad-release axle A are fully released
before operating wheelchair.
– Keep locking pins E clean.
4. If there is too much movement of the rear wheel assembly in a
back and forth motion, refer to 5.6 Removing Play from Rear
Wheels, page 42
56 1171910-A~15