Remote Control; General - Insignia NS-48D420NA16 User Manual

Problem Solution
Audio noise.
• Other devices (for example, a
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control sensor
on the front of the TV.
• Point the remote control directly at
the remote control sensor on your TV.
See
page 31.
• The supplied batteries are wrapped
tightly in clear plastic. Make sure that
you have removed this plastic from
the batteries.
• Make sure that the batteries are
installed correctly. See
remote control batteries
• Replace dead batteries with new
batteries. See
control batteries
67
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
Adjusting sound settings
page 47.
are connected correctly and
securely to your TV.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
Aiming the remote control
Installing
on page 31.
Installing remote
on page 31.
www.insigniaproducts.com
Problem
Trouble
programming
your existing
universal
remote
control.
on

General

Problem
No power.
"No signal"
error message
is displayed.
After Auto
on
Channel
Search, there
are no
channels.
When I press
INPUT, I
cannot select
my device (it is
grayed out).
Insignia 48" 1080p 60Hz LED TV
Solution
• See instructions in Programming
universal remote controls
• Codes are subject to change. For
up-to-date codes, go to
Viewing universal remote control
codes on page 32 or visit
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the manufacturer
if problems persist.
Solution
• Make sure that the power cord is
plugged into a working outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back in
and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may be
interfering with your TV. Try turning
off one device at a time to determine
which device is causing interference.
After you have determined which
device is causing interference, move it
further from the TV to eliminate the
interference.
• Press INPUT and make sure that you
have selected the correct input for the
device or service you are trying to use.
• If you are using a cable or satellite
box, use the remote that came with
that box to change channels.
• Reception can vary by channel
depending on the broadcast power
level of a given station. Contact your
cable or satellite TV provider.
• Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
• Try replacing the cable between the
antenna/cable or cable/satellite box
and your TV.
• Turn on the device. Your TV
automatically detects and displays
which video jacks have devices
connected to them when the devices
are turned on.
• Turn off Auto Input Sensing. See
Turning Input Sensor on or off
page 60.
on page 32.
on