Changing Channel Settings; Automatically Scanning For Channels - Insignia NS-48D420NA16 User Manual

Changing channel settings

This section covers:

• Automatically scanning for channels

• Hiding channels
• Setting up a favorite channel list
• Viewing a favorite channel
• Adding or changing a channel label
• Checking the digital signal strength
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press CH
or CH , your TV goes to the next or previous
channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
1 Press MENU.
2 Press or to highlight CHANNELS, then press
or ENTER.
3 Press or to highlight Auto Channel Search,
then press ENTER or .
4 Press or to highlight Cable/Satellite Box,
Cable from the wall, or Antenna, then press
ENTER.
49 www.insigniaproducts.com
Insignia 48" 1080p 60Hz LED TV
A If you select Cable/Satellite Box, a screen
opens that shows you all the ways you can
connect a box to your TV.
Press ENTER. When a message tells you setup
is complete, press EXIT to close the menu.
Press INPUT to open the INPUT SOURCE list,
then press or to select the video input
source you connected your TV to and press
ENTER. Your TV switches to the input source
you selected.
B If you select Cable from the wall your TV scans
for available channels. The scan may take
several minutes.
When the scan is complete, the first channel
your TV found plays in the background.
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.