Wps - ZyXEL Communications NBG6515 User Manual

The following table describes the general wireless LAN labels in this screen.
Table 22 Wireless Security
LABEL
Wireless Radio
Wireless
Network Name
(SSID)
Security Mode
Wireless
Password
Verify Password
Apply
Cancel

WPS

6.6.7 WPS
Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security to open the following screen.
Figure 37 Wireless Security: WPS
Chapter 6 Easy Mode
DESCRIPTION
Select the wireless radio to set its security setting.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings as
this device. After you select to use a security, additional options appears in this screen.
Select No Security to allow any client to connect to this network without authentication.
This field appears when you choose wither WPA-PSK or WPA2-PSK as the security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Type the password again to confirm.
Click Apply to save your changes back to the NBG.
Click Cancel to close this screen.
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen) to
another wireless device that supports WPS.
NBG6515 User's Guide
47