Navigate A Trail - Lowrance iFINDER Hunt Operation Instructions Manual

3. If the list is short, you can jump directly to the
. Use ↑ or ↓ to select the waypoint name, press
pressing
ENT
waypoint information screen appears with the
4. To begin navigating to the waypoint, press

Navigate a Trail

1. Press
MENU
one below appears.
2. Use ↓ to ↑ to select a trail to navigate.
3. With the trail name highlighted, press
4. Wait while iFINDER creates a route from the trail. When the prog-
ress message disappears, the unit displays a trail information screen,
with the
N
AVIGATE
Tip: Back Track a Trail
Running the Navigate command will lead you along the trail from its
starting point to its ending point. You can also back track a trail, or
follow it in reverse order (from its ending point to its starting point.)
In Easy Mode, this is done automatically with the most recently cre-
ated active trail. In Advanced Mode, you must first select the Reverse
command to reverse the trail point order before you start navigating:
press → to
5. To follow the trail, press
data along the trail. Follow the steering arrow on the Map Page or the
compass bearing arrow on the Navigation Page.
NOTE:
If you are at or near the start of the trail, the arrival alarm will go
off as soon as navigation begins because of your proximity to the
trail's first point. Just press
| |↓ to
MENU
Trails Menu, Advanced Mode.
command highlighted in the top command box.
R
OUTE
|
R R
EVERSE OUTE
|
M T ENT
Y RAILS
ENT
|← to
ENT N
AVIGATE
. The unit begins showing navigation
ENT
to clear the alarm.
EXIT
58
F
IND
command selected.
G T
O O
.
ENT
and a screen similar to the
|↓ to
N
AVIGATE
.
box by
I L
N IST
and the
ENT
| .
ENT