Two Cylinders - 20# Or 30# (44 Or 66 Kilograms) In A Recessed Compartment Or Housing (Fig. 21) - Jayco Eagle 2006 Owner's Manual

Utilities & Systems
I
WARNING: The pigtail hose must be installed to avoid tension or
pulling stress at either end of the hose.
I
WARNING: Keep the pigtail hose away from sharp edges of the
cylinder collar, rigid corners, walls, doors or other compartment
structures including the cover.
.
NOTE: The regulator is typically installed with the inlet fittings at the same level as
the cylinder outlet valves. Due to bracket design, wing nut clearance or cover
restrictions, the regulator fittings may not be in perfect alignment with the cylinder
valves. A variance of two (2) inches (5 cm) above or below the line will permit the
hoses to be properly installed.
Two Cylinders - 20# or 30# (44 or 66 kilograms) In a Recessed
Compartment or Housing (Fig. 21)
Follow these steps to insure the correct container/valve
orientation, regulator placement, hose length, hose routing and
cylinder cover placement for propane supply assemblies.
1. Connect the 3/8" low-pressure hose to the outlet of the
two-stage regulator.
2. Place the cylinder on the bracket in the recess compartment
or housing and secure them so the outlet of the cylinder
valves are facing the "sidewalls" of the compartment or
housing (opposite of each other).
3. Mount the regulator on the center back wall of the
compartment or housing so the vent is pointed downward.
4. Attach the 1/4" inverted flare x 18" Type-1 pigtail hose to the regulator inlet and the
right hand swivel nut to the cylinder valve.
I
WARNING: The pigtail hose must be installed to avoid tension or
pulling stress at either end of the hose.
I
WARNING: Keep the pigtail hose away from sharp edges of the
cylinder collar, rigid corners, walls, doors, or other compartment
structures including the cover.
64 Eagle Conventional Travel Trailer and Fifth-Wheel Travel Trailer
Fig. 21