Tools Required; Slideout Override; Carbon Monoxide (Co) Detector - Jayco Eagle 2006 Owner's Manual

Maintaining Your Investment...
• If the slideout extends crooked, or only one side moves, follow these steps.
= Follow steps on overriding the slideout system.
= You may need to push the side that is not sliding to get it to retract all the way.
= Take your trailer to an independent, authorized dealer or service center.

Tools required

• ScruLox head screwdriver (if trailer has an underbelly)
• 1/2" wrench
• Adjustable wrench or ratchet and 3/4 socket.

SLIDEOUT OVERRIDE

1. If the trailer has an underbelly, locate and
remove the access panel for the slideout motor.
This panel is typically on the opposite side of
the trailer from the slideout room.
2. Use a 3/4 socket and ratchet on the hex head
located on the end of the drive shaft (Fig. 33)
and turn the shaft until the slideout is in the
position you desire.

CARBON MONOXIDE (CO) DETECTOR

Maintenance and testing information for your
carbon monoxide (CO) detector are supplied by the
CO detector manufacturer. Make sure you read, understand and follow all instructions and
safety requirements to maintain the unit's proper operation. If you have questions, consult
with your independent, authorized dealer and/or contact the CO detector manufacturer.
I
WARNING: If the CO detector is not maintained and functioning
properly according to the CO detector manufacturer's supplied
instructions, you will not be warned if CO is present in the air. Death or
serious illness could result from asphyxiation (inability to breathe) if
CO is present.
88 Eagle Conventional Travel Trailer and Fifth-Wheel Travel Trailer
Fig. 33