Table of Contents
Advertisement
MONITOR PANEL
The monitor panel will provide useful information on the capacities of the water tanks and
the battery condition. Your trailer has a wall mounted panel. Follow instructions below
regarding operation. If you have further questions on the operation, refer to information
supplied with your trailer by the monitor panel manufacturer, consult with your
independent, authorized dealer and/or the monitor panel manufacturer.
The panel operates on 12-volt DC power supplied by the converter or battery. Sensors are
installed into the tanks and a resistor assembly relaying a message through wires to the
display board on the panel. No power is drawn from the battery unless a switch is pushed or
turned on.
OPERATION
Spring loaded push button switches are located on the monitor panel. Press only one button
at a time, as one set of lights serve all functions. As you push any button, one or more lights
will come on, indicating the tank contents level.
When pushing the battery button, the highest light illuminating indicates battery condition.
C=charging at 12.7 volts; G=good at 11.9 volts; F=fair at 11.2 volts; and L=low at 6.0
volts.
When the water pump switch is in the "ON" position, the pump runs until 45 pounds of
pressure has been achieved. The red light will stay on. Turn the switch off when the pump
is not in use.
The "gas" water heater switch enables propane operation of the water heater. The "electric"
water heater switch enables electric operation of the water heater.
Fuses for the monitor panel are in the 12-volt distribution center fuse block.
BBQ GRILL PREP
Your unit is equipped with an propane "quick coupler" connection and support bracket for
easy installation of the optional BBQ grill. The "quick coupler" is directly connected to the
propane system of your trailer. Make sure that you read, understand and follow all
information about propane supplied with your unit by various component manufacturers
and this manual.
I
WARNING: Make sure that you read, understand and follow all
information supplied with your RV about propane before operating the
BBQ grill. The propane hose must be correctly connected before
lighting the grill. Failure to follow instructions supplied by the grill
manufacturer with your RV or to use any other components than those
originally supplied with the grill could lead to death or serious injury
from fire or explosion.
The "quick coupler" connection can be attached to the BBQ grill as follows:
1. Place the "quick coupler" handle in the OFF position and push back the sleeve. The
valve handle must be OFF to make the connection. (Fig. 12)
2. Insert the plug at the end of the BBQ grill propane hose and release the sleeve.
Eagle Conventional Travel Trailer and Fifth-Wheel Travel Trailer
At Camp...
53
Advertisement
Table of Contents
