Extending Room; Retracting Room; Booth Dinette To Bed Conversion - Jayco Eagle 2006 Owner's Manual

Setting Up Camp...
Caution: After the slideout is extended, verify that the corners of
the black rubber seal are set up correctly. The corners of this seal
are cut at a 45 degree angle. The top of the seal must overlap the
side of the seal to avoid the possibility of water penetration. Fig. 6

Extending Room

1. The batteries must be fully charged and connected. The travel
trailer should be hooked up to 120-volt AC power and have
power converter operating, if possible.
2. The travel trailer must be level and the stabilizer jacks in the
down position.
Caution: Additional support jacks are not needed under the slideout.
Damage can occur to your slideout room from improper use of support
jacks.
3. Locate the slideout room control switch (Fig. 7).
4. To move the room out, press the "OUT" section of the switch and
hold it until the motor stops. Operating the switch after the room is
fully extended will damage the switch and motor. Travel time -
approximately twenty-five seconds.

Retracting Room

1. Remove all objects left between the slideout and cabinetry.
2. Press the "IN" section of the switch and hold it until the motor stops. Operating the
switch after room is fully retracted will damage the switch and motor.

BOOTH DINETTE TO BED CONVERSION

1. Remove the table top and cushions. Place them to the side.
2. Remove the table legs from the floor brackets and place them in one of the storage
compartments of the dinette seats. Place the storage cover back on the dinette seat.
3. Place the table top across the middle from one dinette seat to the other resting on the
front edge bracket. For comfort, make sure the table top is level with the top of the
dinette bench.
4. Position the dinette bench cushions in place across the benches and the table top.
To convert back to the booth dinette, reverse the procedures above.
42 Eagle Conventional Travel Trailer and Fifth-Wheel Travel Trailer
Fig. 6
Fig. 7