Table of Contents
Advertisement
4. Highlight
L
with the following options: Port, Center, Starboard and Unknown.
5. Select the desired location and press
sage will appear: Are you sure you wish to change this device's configuration?
6. Press
. Press
ENT
To select Engine Type:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Use ↑ ↓ to select the desired engine interface and press
vice Configuration menu will appear.
4. Highlight
E
menu with the following options: DF40, DF50, DF60, DF70, DF90/115,
DF140, DF150, DF175, DF200/225, DF250 and DF300.
5. Select your engine type and press
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
main display.
Advanced Options menu
The Engine Interface Advanced Options menu contains three categories:
Instance, Restore Defaults and Reset Trim Calibration.
Instance
The Instance command is intended for use only by experienced NMEA 2000
network technicians. Instance allows network technicians to resolve certain
electronic probe conflicts. This is most likely to occur if the network includes
LMF-200 or LMF-400 digital gauges, which support the display of fewer elec-
tronic probes than your GPS or sonar/GPS unit. If you want to use your unit in
a network including one of these digital gauges, you may need to consult cus-
tomer service. You should never need this command if you are connecting your
unit to a network with similar display units and/or a series of electronic
probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual engine
interface's settings to factory defaults. If, for example, you execute the Re-
store Defaults command from your Port Engine Interface Advanced Options
menu, only the settings for the Port Engine Interface will be reset to factory
defaults. Other engine interfaces on the network will not be affected.
and press
OCATION
repeatedly to get back to the main display.
EXIT
, use ↑ ↓ to select
and press
S
US
ETUP
and press
T
NGINE
YPE
and press
ENT
ES
, which will open the Location menu
ENT
. The following confirmation mes-
ENT
NMEA 2000
, which will open the Bus Configu-
ENT
, which will open the Engine Type
ENT
. The following message will
ENT
. Press
repeatedly to get back to the
EXIT
133
and press
ENT
. The De-
ENT
. The
Advertisement
Table of Contents
