Table of Contents
Advertisement
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute the
Restore Defaults command from your Water Temp's Advanced Options
menu, only the settings for the Water Temp will be reset to factory de-
faults. Other temps on the network will not be affected.
To restore default settings
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
tion menu will appear.
4. Highlight
A
5. Select
R
ESTORE
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
main display.
EP-10 Fuel Flow Configuration
To input Device Name:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the fuel flow you want to rename and press
figuration menu will appear with the Device Name dialog box highlighted.
4. Press
ENTER
flow. Press
ENT
To select a Location:
1. Press
MENU| MENU
2000 menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
menu will appear.
:
, use ↑ ↓ to select
and press
S
US
ETUP
O
DVANCED
PTIONS
and press
D
EFAULTS
and press
ENT
ES
, use ↑ ↓ to select
and press
S
US
ETUP
and use ↑ ↓, ← → to input the desired name for the fuel
. Press
repeatedly to get back to the main display.
EXIT
, use ↑ ↓ to select
and press
S
US
ETUP
NMEA 2000
, which will open the Bus Configu-
ENT
and press
ENT
. The following message will
ENT
. Press
EXIT
NMEA 2000
, which will open the Bus Configu-
ENT
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
128
and press
. The Device Configura-
ENT
.
repeatedly to get back to the
and press
. The Device Con-
ENT
and press
ENT
. The Device Configuration
. The
ENT
. The
ENT
. The NMEA
Advertisement
Table of Contents
