Removing The Drive-Bay Heat-Sensor; Prerequisites; Procedure - Alienware Area-51 R2 Service Manual

Removing the Drive-Bay
Heat-Sensor
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in After Working Inside Your
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.

Prerequisites

1
Remove the
2 Remove both the left and right side-panels. See
Panels".

Procedure

1 Lay the chassis on the left side.
2
Locate the drive-bay heat-sensor connector (SENSOR1) on the system
board. For more information on the drive-bay heat-sensor connector, see
"System-Board
58
Before Working Inside Your
stability foot.
Components".
Computer. For more safety best
"Removing the Side
Computer.