Replacing The Stability Foot; Procedure - Alienware Area-51 R2 Service Manual

Replacing the Stability Foot

WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in After Working Inside Your
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.

Procedure

1
Tilt the computer towards the front until the base is facing up.
2 Align the screw holes on the stability foot with the screw holes on the base
of the computer and replace the screws.
3 Tilt the computer back to the upright position.
Before Working Inside Your
Computer. For more safety best
Computer.
25