Installing Remote Fibre-Channel Boot Support For A Windows 2000 Host System; Configure Zoning And Obtain Storage - IBM TotalStorage DS6000 Attachment Manual

4. If the value exists and is less than 0x0000003c (60 decimal), perform the
5. Exit the Regedt32 program.
6. Restart your Windows 2000 server for the changes to take effect.
Installing remote fibre-channel boot support for a Windows 2000 host
system
This section provides instructions for installing remote fibre-channel boot support for
a Windows 2000 host system.
You must obtain the following items before beginning to install remote fibre-channel
boot support:
v The IBM TotalStorage Enterprise Storage Server Subsystem Device Driver User's
v The IBM TotalStorage DS6000 Introduction and Planning Guide.
v Either the Windows 2000 CD-ROM or a set of Windows 2000 setup floppy disks
v The Windows 2000 installation instructions.
v Ensure that the host adapters are installed and cable connections of the host,
v The supported fibre-channel host adapter driver package.
v The supported fibre-channel host adapter driver documentation.
v Extract and copy the driver files to a floppy.
Remote fibre-channel boot support is available for Windows 2000 with or without
SDD. For information on the SDD hardware and software installation requirements,
see IBM TotalStorage Multipath Subsystem Device Driver User's Guide.

Configure zoning and obtain storage

1. Reboot the host system to obtain the Host Bus Adapter WWPN:
2. Configure appropriate zoning on the switch to include only the storage unit
3. Use the IBM TotalStorage DS Storage Manager to add the host system to the
following steps to increase it to 0x3c.
a. Click TimeOutValue.
b. Click Edit → DWORD....
c. For data, type: 3c.
d. For radix, click Hex.
e. Click OK.
Guide.
with the Windows 2000 CD-ROM.
switch, and storage unit are complete and functional.
a. For QLogic host adapters: A QLogic BIOS banner appears, press <Alt Q>
or press <Ctrl Q> as indicated, depending on the BIOS level. For each host
adapter, select Configuration Settings -> Host Bus Adapter Settings and
write down the host adapter WWPN.
b. For Emulex host adapters: When the BIOS banner appears, press either
<Alt E> or press <Alt F5> as indicated, depending on the BIOS level. A list
of adapters is displayed. For each host adapter, select the adapter and write
down the host adapter WWPN.
WWPN and one host adapter WWPN.
list of host systems that are available for attachment to the storage unit. For
detailed information of how to use the IBM TotalStorage DS Storage Manager,
refer to the IBM TotalStorage DS6000 Introduction and Planning Guide.
Chapter 19. Attaching to a Windows 2000 host
193