Parameter Settings For The Qlogic Qla23Xx Adapters For San Surf Configuration (4.06+ Driver); Parameter Settings For The Qlogic Qla23Xx Host Adapters For San Surf Configuration (4.06+) - IBM TotalStorage DS6000 Attachment Manual

Parameter settings for the QLogic QLA23xx adapters for San Surf
configuration (4.06+ driver)
The following table provides the parameter settings for the QLogic QLA23xx
adapters for storage units with the San Surf configuration (4.06+ driver).
Table 13 provides the QLogic QLA23xx adapter settings for storage units with the
4.06+ driver of the San Surf configuration.
Table 12. Recommended configuration file parameters for the QLogic QLA2310F, QLA2340,
and QLA2342 adapters with driver level 4.03 (continued)
Parameters
hba0-enable or disable-target-reset
hba0-reset-delay
hba0-port-down-retry-count
hba0-link-down-error
hba0-loop-down-timeout
hba0-connection-options
hba0-device-configuration-mode
hba0-fc-tape
hba0-fc-data-rate
hba0-command-completion-option
persistent binding only option
Table 13. Parameter settings for the QLogic QLA23xx host adapters for San Surf
Configuration (4.06+)
Adapter parameter
Host Parameters
Execution Throttle
Frame Length
Port Down Retry Count
Connection Options
Enable Fibre Channel Tape Support
Enable Fibre Channel Confirm
Data Rate
Advanced Host Parameters (See Note 1)
Persistent Plus New
Persistent Target Only
Persistent Bind HBA
Recommended settings
=0: disabled
=5;
=30;
=1: enabled
=60;
v =0: loop only (for direct attachment)
v =1: point-to-point only (for fabric
attachment)
=1: use port name
v =0: disabled
v =1: enabled
=2: Auto-negotiate
=0: response queue
=0: reports the discovery of persistent binded
and non-binded devices to the operating
system
Recommended settings
16 (default)
2048
30
v Loop Only
v Loop Retreived
v Point-to-Point
Enable
Enable
2 Auto Negotiate
Enable
Disable
Disable
Chapter 18. Attaching to a Sun host
175