Installing Fibre Channel Tape Drive Cables - IBM Universal Tape Library User Manual

Figure 11. Installing the SCSI host interface cables
16. Connect the power cords to the power supplies and the power source.
17. Install the tape cartridges. For more information, see "Installing tape cartridges"
18. Turn on the library. For more information, see "Turning the library on and off"
19. Configure the library. For more information, see "Configuring the library" on

Installing Fibre Channel tape drive cables

Notes:
1. Fibre Channel cables are not provided and must be purchased separately.
2. This document describes basic Fibre Channel installations. More complicated
If you have installed a Fibre Channel tape drive, complete the following steps:
1. Connect the Fibre Channel host interface cable to the host server.
Figure 12. Installing the Fibre Channel host interface cables
2. Connect the Fibre Channel host interface cable to the tape drive.
Host system
SCSI jumper cables
on page 14.
on page 14.
page 15.
installations such as SANs, switches, and hubs are beyond the scope of this
document.
SCSI terminator
Host system
Chapter 2. Installing and configuring the library
13