Chapter 12. Attaching to an Intel host running VMware ESX
server
This chapter provides instructions, requirements, and considerations for attaching
an Intel host system running VMware ESX server to a storage unit.
Supported adapter cards for an Intel host running VMware ESX Server
This section provides a list of the supported adapter cards for an Intel host running
VMware ESX Server.
This section describes how to attach an Intel server running VMware to a storage
unit with the following fibre-channel adapters:
v QLogic QLA2310FL adapter card
v QLogic QLA2340FL adapter card
v QLogic QLA2342FL adapter card
v Emulex LP9402DC adapter card
v Emulex LP9802 adapter card
For up-to-date information about the servers, operating systems, distribution levels,
host adapters, and fabric connections that IBM supports, see the Interoperability
Matrix at http://www.ibm.com/servers/storage/disk/ds6000/interop.html.
Note: The steps to install and configure adapter cards are examples. Your
Attaching with fibre-channel adapters
This section describes how to attach an Intel server that is running a VMware ESX
2.5.1 server or a later server to an IBM storage unit.
For information about the most current version of the switches that are supported,
see the Interoperability Matrix at
http://www.ibm.com/servers/storage/disk/ds6000/interop.html.
Attachment requirements for an Intel host running VMware ESX server
This section provides attachment requirements for an Intel host running VMware
ESX Server.
v Check the LUN limitations according to the following information.
© Copyright IBM Corp. 2004, 2005
configuration might be different.
Number of paths (either more HBAs on the
host or more ports on storage)
1
2
4
8
16
32
Note: The limitation calculated is a combination of the VMware limitations:
Maximum number of LUNs configured
on storage / HBA
64
64
64
64
64
31
123