Assembly - Pro-Form StrideClimber 490 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M4 x 19mm
Screw (75)–4
19mm Wave
Washer (71)–4 M8 x 25mm M10 x 25mm
Washer (54)–4 Washer (52)–4
M4 x 50mm
Screw (76)–4
M8 x 16mm Button M8 x 20mm Button M8 x 30mm Button
Screw (53)–4 Screw (77)–2 Screw (67)–4
M8 x 35mm Button M8 x 50mm Button
M10 x 20mm Button
Screw (80)–2 Screw (65)–2
Screw (58)–4
5