Connect Lcd Screen And Antenna(E) To The Signal Box - Loewe Spheros 32 HD Operating Instructions Manual

Connect LCD screen and antenna(e) to the Signal Box

TFT-LCD monitor
Switch on/off
Signal Box
ANT-2
UHF/VHF
PIP
L
AUDIO OUT
The antenna sockets 1 and 2 are only available in the set version with "Digital-TV upgrade kit 2 Sat/Twin-Sat CI".
The connection socket "CONTROL" is only available for Spheros 32/37 HD and designed for a Motor Unit!
Note: For optimum picture resolution use the "Digital Visual Interface Input DVI" only connecting cables less than 2 meters long.
8
31963_021_RC3_GB
CONTROL AC INPUT
DVI-INPUT
AV 1
AV 2 ( RGB )
R L R
L R Center Sub
AUDIO IN 3 SOURROUND
SERVICE
R
TV
8
D-SUB
220V-240Volt
VGA
DIGITAL
IN1 IN2 OUT
AUDIO IN1
L R
CONTROL
Y
C /P
B B
C /P
R R
RC5/ AUDIO
IR-
SYSTEM
DVI-INPUT D-SUB
RC6 Link IN 2
14.01.2005, 10:40 Uhr
Removing the connection cover
Do not just pull the cover (fig.) back
over the connections.
Reach into the opening in the cover
and pull it back slightly at the top until
it snaps open. Then pull the cover up
and out.
Connect both the system cables and
the power cable to the LCD screen as
shown in the figure.
Then replace the cover.
120-240V
50/60Hz
DVI-OUTPUT
DISPLAY