Tips for removing the headlamp
(halogen model)
To allow the headlamp to be moved forward
a few centimetres for access to the bulbs,
proceed as follows:
Move the orange clip towards the rear
then while pressing on the black part
(located above the orange clip) pull on the
connector.
Remove the two screws holding the lamp.
Disengage the rear pin then the front
centre piece.
Move the lamp forwards.
Dipped beam headlamps
(halogen model)
Remove the protective plastic cover by
pulling on the tab.
Disconnect the bulb connector.
Disengage the two springs (press then
move them outwards).
Extract the bulb by pulling and change it.
For reassembly, carry out these operations in
reverse order.
Practical information
Main beam headlamps
(halogen model)
Remove the protective plastic cover by
pulling on the tab.
Turn the connector (with its bulb) towards
the top (1/4 turn).
Remove the bulb by pulling it out and
change it.
For reassembly, carry out these operations in
reverse order.
Be aware that the area behind the
right-hand headlamp (facing forwards)
may be hot, with the risk of burns
(overflow pipe).
7
237