Cradlepoint IBR600 Product Manual page 103

IBR600 | USER MANUAL Firmware ver. 4.0.2
CRADLEPOINT
7.1.3 General Settings
 Enabled: Select/deselect to
enable/disable.
 Force NAT: Normally NAT is part of the
Routing Mode setting which is selected
on the LAN side in Network Settings →
WiFi / Local Networks. Select this option
to force NAT whenever this WAN device
is being used.
 Priority: This number controls failover
and failback order. The lower the number,
the higher the priority and the more use
the device will get. This number will
change when you move devices around
with the priority arrows in the WAN
Interfaces list.
 Load Balance: Select to allow this device
to be available for the Load Balance pool.
 Download bandwidth: Defines the
default download bandwidth for use in
Load Balance and QoS (quality of service, or traffic shaping) algorithms. (Range: 128 Kb/s to 1 Gb/s.)
 Upload bandwidth: Defines the default upload bandwidth for use in Load Balance and QoS (quality of service, or
traffic shaping) algorithms. (Range: 128 Kb/s to 1 Gb/s.)
 MTU: Maximum transmission unit. This is the size of the largest protocol data unit that the device can pass.
(Range: 46 to 1500 Bytes.)
 Hostname (This only shows for certain devices.)
© 2012 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 101