Table of Contents
Advertisement
To raise the rear seatback(s):
WARNING:
{
A safety belt that is improperly routed, not properly
attached, or twisted will not provide the protection
needed in a crash. The person wearing the belt
could be seriously injured. After raising the rear
seatback, always check to be sure that the safety
belts are properly routed and attached, and are
not twisted.
1. Lift the seatback up and push rearward until you
hear a click. Keep the safety belt clear of the seat
and not twisted.
The release knob on the top of the seatback has a
red ring. If the seatback is not fully latched this
ring will be visible. Push on the seatback until the
ring is not visible.
WARNING:
{
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
pull forward on the top of the seatback at the area
of the latch to be sure it is locked.
2. Push and pull on the seatback to make sure it is
locked in place.
2-13
Advertisement
Chapters
Table of Contents
