Video Out Menu - Sony BRC-Z330 Operating Instructions Manual

IMG-FLIP to OFF, then turn the power off and on
again, PAN REVERSE and TILT REVERSE will be
set to OFF.
• If you set IMG-FLIP to ON, the remote sensor at the
rear of the camera does not function.
DISPLAY INFO (information display)
When the camera settings are stored in POSITION 1 to
16 using the supplied Remote Commander or the RM-
BR300 Remote Control Unit, the message "PRESET
No. xx" automatically appears for 2 seconds on the
monitor screen. If you want to display the message each
time the camera is operated, set DISPLAY INFO to ON.
Set it to OFF to cancel the display.
Note
The message will appear if the built-in cooling fan of the
camera has accidentally stopped. When DISPLAY
INFO is set to OFF, the display of this message is also
canceled.
SYNC MASTER
When you connect a sync signal generator, you can
select an output video signal that is synchronized with
the external video sync signal input to the EXT SYNC
IN connector on the camera from among the following
output signals:
HD: Selects the output signal from the
COMPONENT connector on the camera.
SD: Selects the output signal from the
S VIDEO connector on the camera.
When outputting from the SDI connector, select "HD"
for HD-SDI signal, or "SD" for SD-SDI signal.
H PHASE
When you connect a sync signal generator, adjust the
horizontal phase so that the output signal is
synchronized with the external sync signal input to the
camera. The adjustable range is from 0 to 140.
When you select H PHASE on the menu, the message
"PUSH ENTER BUTTON" appears on the screen. Press
the HOME button on the Remote Commander or the
button on the top of the joystick on the Remote Control
Unit to make the color bars appear.
After completing the adjustment, press the HOME
button on the Remote Commander or the button on the
top of the joystick on the Remote Control Unit to make
the color bar disappear.
Note
The H PHASE menu does not appear when a BRU-SF10
HD Optical Multiplex Unit is in use.
38

VIDEO OUT Menu

VIDEO OUT Menu
HD-RGB/COMPONENT
FORMAT
Select the signal output from the
COMPONENT connector on the camera.
YP P : Outputs analog component signals.
B R
RGB: Outputs RGB signals.
When you select a mode for FORMAT, some of the
following setting items that are required for selected
mode appear.
ADD SYNC: Specifies whether to add a sync signal.
RGB/
Setting the item to RGB specifies output of each R,
G, and B signal with a sync signal added. Setting
VIDEO or
the item to OFF specifies output of each R, G, and
B signal with no sync signal added.
SYNC TYPE: Specifies the type of sync signal. Setting
the item to
sync. Setting the item to VD specifies output of bi-
level sync.
SD-VIDEO/S VIDEO
IMG SIZE
Select the aspect ratio of the signal output from the
VIDEO or
16:9[LETTER]: The image is displayed in 16:9
letterbox.
4:3[CROP]: The image is displayed in 4:3 edge crop.
4:3[SQUEEZE]: The image is displayed in 4:3
squeeze.
SETUP
Select whether 7.5IRE setup is added to output signals.
ON: Outputs signals with 7.5IRE setup added.
OFF: Outputs signals with no 7.5IRE setup added.
< V I D E O O U T >
H D - R G B / C O M P O N E N T
> F O R M A T Y P
S Y N C T Y P E S Y N C
S D - V I D E O / S V I D E O
I M G S I Z E 1 6 : 9 [ L E T T E R ]
S E T U P O F F
RGB/
SYNC specifies output of tri-level
S VIDEO connector on the camera.
P
B R