Operating A Brc-Z330 Camera From A Long Distance - Sony BRC-Z330 Operating Instructions Manual

Operating a BRC-Z330 Camera from a Long Distance

This system allows you:
• To operate the camera remotely from a distance up to 2,000 m (6,562 feet)
• To perform pan/tilt and zoom operations using the joystick
• To transmit the video signal and control signal of the camera to a distant place using the Optical Fiber Cable
System configuration
BRC-Z330
BRBK-SF1 HD Optical Multiplex Card
Video signal
Remote control (VISCA) signal
,
Signal flow
1)
Using the supplied extension plug allows transmission distances up to 2,000 m (6,562 feet).
Notes
• Be sure to turn on the power of the BRC-Z330 camera before you turn on the power of the BRU-SF10 HD Optical
Multiplex Unit.
• The BRC-Z330 camera does not operate if nothing is connected to the BRBK-SF1 HD Optical Multiplex Card
inserted into the camera. To operate the camera, connect the BRU-SF10 Optical Multiplex Unit to the BRBK-SF1
using the CCFC-S200 Optical Fiber Cable and turn on the power of the BRU-SF10.
• When the BRBK-SF1 HD Optical Multiplex Card is inserted into the BRC-Z330 camera, the EXT SYNC IN
connector, VISCA RS-232C IN/OUT connectors, VISCA RS-422 connector, DATA MIX switch, and 75-ohm
termination switch on the rear of the camera and the BOTTOM switches on the bottom of the camera are disabled.
Use the connectors and switches on the rear of the BRU-SF10 Optical Multiplex Unit instead.
• Only the 59.94/50 signal format selector (switch 1) and the 1080i/720p signal format selector (switch 2) BOTTOM
switches on the BRC-Z330 camera are enabled. For the switches that are disabled, use the switches on the rear of the
BRU-SF10 HD Optical Multiplex Unit instead.
• The optional CCFC-S200 Optical Fiber Cable cannot be used with this system.
CCFC-S200 Optical Fiber Cable
HD video monitor, VTR, etc.
1)
RM-BR300 Remote Control Unit
BRU-SF10
Optical Multiplex
Unit
15
System Configuration