Configure Res.code (Result Code); Configure Last Channel Protect - AOR AR-DV1 Operating Manual

Press the [▼] key to select "REMOTE.BPS" parameter in reverse contrast. Rotate the dial knob to select
the desired baud rate from 9600, 19200, 38400, 57600, 115200 bps. The default setting is 115200 bps.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.

9-9 CONFIGURE RES.CODE (RESULT CODE)

The RES.CODE set menu is used to choose if the result code to be added at the head of the response
message of the remote command.
The selection is ON or OFF. The default setting is ON.
To access the configuration menu, press the [F] key and then the [7] key.
Press the [▼] key to select "RES.CODE" parameter in reverse contrast. Rotate the dial knob to select
ON or OFF.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.

9-10 CONFIGURE LAST CHANNEL PROTECT

This menu is used to configure if the last channel memory is to be write-protected.
The selection is ON or OFF. The default setting is OFF.
Please refer to "Last Channel Memory" for details.
To access the configuration menu, press the [F] key and then the [7] key.
Press the [▼] key to select "PROTECT" parameter in reverse contrast. Rotate the dial knob to select the
ON or OFF.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.
49