Program Search - AOR AR-DV1 Operating Manual

8-1-2 PROGRAM SEARCH

The AR-DV1 has 40 program search banks (referred to simply as search banks) which can be
programmed with specific parameters:
LO (lower) start frequency
HI (upper) stop frequency
Receive mode (or set to AUTO MODE)
Text comment
The program search banks are identified by numbers (00 ~ 39). To help with identification, each bank
may be labeled with an alphanumeric text comment.
8-1-2-1 STARTING PROGRAM SEARCH
Presuming that data is already stored into a search bank.
Press the [SRCH] key to start the program search process.
"SER" icon will be displayed on the top left of the LCD. As long as the squelch is closed, the
search process will start from the lower frequency limit and will progress toward the upper frequency
limit. When the program limit is reached, the search loops around and starts the process again.
Note: If no search banks have been programmed, the search will not operate.
8-1-2-2 REVERSING THE SEARCH DIRECTION
To reverse the search direction, rotate the dial knob or press the [▼] key or the [▲] key.
This is useful to enable you to search back over an interesting point of the search process.
8-1-2-3 FORCING THE SEARCH TO RESUME
If the AR-DV1 stops on an unwanted busy frequency, rotate the dial knob or press the [▼] key or
[▲] key to force the search process to resume from the current frequency displayed.
8-1-2-4 STOPPING THE SEARCH
While the search process is in progress (not stopped), press the [VFO] key (displaying the data
on-screen before search was started).
8-1-2-5 SELECTION OF SEARCH BANK
There are 40 search banks. Select a search bank by entering its two digit number into the keypad.
41