Programming Keypad Lock - Robertshaw 9710 User Manual

PROGRAMMING
2. Press SET button. The display will show the current day of the
week or the last programmed day. Press ∨ or ∧ to advance to
the day of the week you will program.
3. Press SET button. The display will show the time setting:
4. Press either ∨ or ∧ button to adjust the time setting for MORN.
(Note: Either ∨ or ∧ button scrolls the time in 30 minute
increments.)
5. Press SET button. The display will show the setpoint
temperature (70˚ for winter, heat program or 78˚ for summer,
cool program).
6. Press either ∨ or ∧ button to adjust the temperature setpoint
for the programmed MORN time.

Programming Keypad Lock

NOTE: In order for the lock function to work as described below, the "LOCK" function must have been enabled during
installation. If the Lock function does not seem to work, you must change a dip switch located on the back of the
thermostat. See "CHANGING DIP SWITCH SETTINGS" section to turn the "LOCK" function on.
This thermostat has a keypad lock that will prevent unauthorized program changes. When the keypad is locked, the
user must enter the 3-digit combination or the keypad will not allow programming changes.
IMPORTANT: Please write down your chosen 3-digit combination in a convenient location away from the thermostat.
The thermostat WILL NOT let you change the settings or the mode if you forget the combination. When the
thermostat "LOCK" function is on, only the LOCK keypad button is functional until the thermostat is unlocked.
Setting your combination and lock keypad:
1. Press SET and LOCK buttons at the same time. Release both
buttons. The display will show "000." The first digit will flash.
2. Press ∨ or ∧ button to enter the first (left) digit.
3. Press SET button to save first digit. The second digit will flash.
4. Press ∨ or ∧ button to enter the second (middle) digit.
PROGRAMMING
SET
MON
SET
MON
SET
MON
SET
LOCK
SET
18
AM MORN
F
MORN
23