Returning To Factory Default Settings - Argox G6000 User Manual

Printing Configuration Report
Performing the Self Test
1. Turn off the printer. Press and hold the FEED button.
2. Turn on the power.
3. When the message "SELF TESTING ..." is displayed on the LCD and
READY indicator blinks, release the button.
4. The printer will print out a configuration report.
5. Finally the "READY" message is displayed and the READY indicator
stops blinking and lights up.
6. The following information will be printed on this report.
- Font list
- DIP switch settings
- Hardware configuration and status
- Label parameters
- Firmware version
Note:
After self test the printer will enter character dump mode. For normal
operation press the CANCEL button to stop dump mode.
31

Returning to Factory Default Settings

If you would like to reset the printer to its factory defaults after certain
commands have been sent or settings changed:
1. Turn off the printer. Press and hold the CANCEL button.
2. Turn on the power.
3. When the message " E2PROM RESET ..." is displayed on the LCD and
READY indicator blinks, release the button.
4. Finally the "READY" message is displayed and the READY indicator
stops blinking and lights up.
5. The following parameters automatically reset.
- Label parameters
- Heat(Darkness)
- Speed
- Symbol set (language)
- Others for specific emulation
Notes :
1. All settings stored in non-volatile E
by turning the printer off.
2. The settings of DIP switch can not be reset.
3. It is necessary to perform label sensitivity calibration after resetting.
4. The printed label count can not be reset.
2
PROM cannot be destroyed even
32