Rear Panel; Printing Configuration Report; Performing The Self Test - Argox G6000 User Manual

Rear Panel

The rear panel includes
- An 8-bit DIP switch
- A 36-pin parallel port
- A 9-pin RS-232 serial port
- A PS/2 keyboard connector
- A power switch and power connector
DIP Switch
PS/2 KB I/F
Power Connector
29
Centronics
RS-232
Serial Port
Power Switch

Printing Configuration Report

Performing the Self Test

1. Turn off the printer. Press and hold the FEED button.
2. Turn on the power.
3. When the message "SELF TESTING ..." is displayed on the LCD and
READY indicator blinks, release the button.
4. The printer will print out a configuration report.
5. Finally the "READY" message is displayed and the READY indicator
stops blinking and lights up.
6. The following information will be printed on this report.
- Font list
- DIP switch settings
- Hardware configuration and status
- Label parameters
- Firmware version
Note:
After self test the printer will enter character dump mode. For normal
operation press the CANCEL button to stop dump mode.
30