Control Panel - Supero SUPERSERVER 2027TR-D70RF+ User Manual

SUPERSERVER 2027TR-D70RF+ USER'S MANUAL
Node A Control Panel
6-2

Control Panel

Each control panel on the front of the chassis must be connected to the JF2
connector on its associated serverboard to provide you with system control buttons
and status indicators.
These wires have been bundled together in a ribbon cable to simplify the connection.
Connect the cable from JF2 on the serverboard to the control panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all
excess cabling out of the airfl ow path. The LEDs inform you of system status for
the serverboard it is connected to. See Chapter 3 for details on the LEDs and the
control panel buttons.
Figure 6-1. Chassis Front View
Hard Drives
Figure 6-2. Chassis Rear View
Power
Supply
VGA Port
LAN Ports
USB Ports
6-2
Node B Control Panel