Installing MicroLP Cards (Figure 6-17)
1. Pull out the motherboard node drawer from the chassis. It is not necessary to
power down the system when removing a node.
2. Open the PCI slot clip in the rear of the motherboard node drawer.
3. Remove the PCI slot shield.
4. Slide the MicroLP card into the PCI slot shield and fi t the MicroLP card
bracket with the opening in the rear of the motherboard node drawer.
5. Close and secure the MicroLP card bracket and then secure the MicroLP card
screw.
6. Close the cover, reconnect to the power source and power-up the chassis.
MicroLP
Card Screw
PCI Slot Shield
Figure 6-16: Installing the MicroLP Card
MicroLP Card
6-17
Chapter 6: Advanced Chassis Setup