Table of Contents
Advertisement
Replacing the Electronic Flash Assembly
•
Do 1 through 13 on Figure 3-9 in reverse order.
•
If the Left Holder 11 was removed from the Flash Assembly, on reassembly be sure the
molded pin on the Left Hub is positioned as shown in Figure 3-10; at approximately
8 o'clock, above the arm of the Flash Switch. Before completing reassembly, check
that when the Flash Unit is swung upward to its vertical position, the molded pin
depresses the Switch arm.
Figure 3-10. Left hub pin position (electronic flash)
40
Hide quick links:
Advertisement
Table of Contents
