Adding And Replacing Components In An Existing System - Honeywell evohome Installation Manual

Adding and replacing components in an existing system

evohome Installation Guide
Adding and replacing components in an
existing system
On the evohome Controller press and
1
hold "Settings" for 3 seconds
Press the green tick
2
To change a device in a zone press ZONE SETTINGS
3
and select the zone name To add or change an actuator
Press the application button then next and follow
4
the instructions to bind a new actuator
To change the sensor press the sensor button, select
5
the type of sensor or next and follow the instructions
to bind a sensor. If the old product is not required
in the system remember to remove the batteries as
it may still try to communicate with the system.
To change a boiler relay, system valve,
hot water component or remote gateway
Press SYSTEM DEVICE
1
Select the type of device and follow the instructions
2
to bind. If the old product is not required in the
system remember to remove the power as it may
still try to communicate with the system.
39