To Bind The Actuator - Honeywell evohome Installation Manual

evohome Installation Guide

To bind the actuator

Press the bind button on the Radiator Controller (if there
6
are multiple HR80's in the zone, do this to all of them).
The screen should show a flashing RF icon
On the evohome Controller press
7
the green bind button
Check that (all) the Radiator Controllers display SYNC.
8
If a Radiator Controller does not display SYNC and
the flashing RF icon
evohome Controller and send the bind signal again
Press the next arrow on the evohome Controller
9
Press the green tick
10
to the zone — OR — Press the red cross
don't need to add another radiator to the zone
remains, press back on the
to add another radiator
23
if you