Edit Zone Config; System Parameters; Binding And Rf Test - Honeywell EVOTOUCH CONTROLLER Installation Manual

System Configuration
The System Configuration menu provides access to the Installer
configuration options.
To display the System Configuration menu:
• Press MENU on the home screen for ten seconds.
The following warning will be displayed:
• Press YES to continue.
The System Configuration menu will then be displayed. This
provides the following options:
These are described in greater detail in the following sections.
Guided Config
Leads you through the essential steps in setting up a system. For
more information see the Installation Guide.
Edit System Config
See Edit System Configuration, page 4.
Factory Reset
Resets all settings to their factory defaults. The following prompt
is displayed:
• Press YES to continue.
Note: After a factory reset the system configuration is also lost.

Edit Zone Config

Allows you to edit the name, application, and sensor assigned to
each zone. See Edit Zone Configuration, page 4.

System Parameters

Allows you to set parameters affecting the operation of the whole
system. See System Parameters, page 8.

Binding and RF Test

Allows you to bind or test sensors or actuators throughout the
system. See Binding and RF Test, page 9.
3