Wireless Relay Box (Bdr91) - Honeywell evohome Installation Manual

Wireless Relay Box (BDR91)

evohome
Controller
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
'Settings' for 3
seconds
2. Press the green tick
3. Press SYSTEM
DEVICES
4. Press the button next
to 'Boiler Demand'
5. Press BOILER RELAY
or OPENTHERM
BRIDGE
evohome Installation Guide
Power up and bind a Wireless Relay Box
(BDR91) or OpenTherm Bridge (R8810) to
control a boiler
Make sure the Wireless Relay Box (BDR91) or
OpenTherm Bridge (R8810) is wired to the boiler and
powered up.
To bind the Relay Box or OpenTherm Bridge
Press and hold the button for 15 seconds (until the red
1
LED blinks rapidly) to clear any previous binding data
Press and hold the button again for 5 seconds
2
(until the red LED blinks slowly)
On the evohome Controller press
3
the green bind button
You should receive a SUCCESS message on the
4
evohome Controller (if not go back and re-bind)
1
15 SEC
2
HOLD
19
HOLD
5 SEC