Honeywell evohome Installation Manual page 30

28 Step 3: Power up and bind devices
To bind the Room Temperature
Sensor (HCW82 or HCF82)
Press the bind button on the bottom right hand corner
1
of the unit once. The red LED light will flash
You should receive a SUCCESS message on the
2
evohome Controller (if not go back and re-bind)
1
Then on the Mixing Valve Controller
Press and hold both buttons on the Mixing Valve
1
Controller for 4 seconds until the red light flashes
On the evohome Controller press
2
the green bind button
You should receive a SUCCESS message on the
3
evohome Controller (if not go back and re-bind)
1
PRESS
AND HOLD
4 SEC