To Bind The Room Temperature Sensor (Hcw82 Or Hcf82) - Honeywell evohome Installation Manual

evohome Installation Guide
To bind the Room Temperature
Sensor (HCW82 or HCF82)
Press the bind button on the bottom right hand corner
1
of the unit once. The red LED light will flash
You should receive a SUCCESS message on the
2
evohome Controller (if not go back and re-bind)
1
Then, on the Wireless Relay Box (BDR91)
Press and hold the button for 15 seconds (until the red
1
LED blinks rapidly) to clear any previous binding data
Press and hold the button again for 5 seconds
2
(until the red LED blinks slowly)
On the evohome Controller press
3
the green bind button
You should receive a SUCCESS message on the
4
evohome Controller (if not go back and re-bind)
1 2
HOLD
15 SEC
21
HOLD
5 SEC