Epson TM-H6000 Service Manual page 67

Confidential
48. Attach the RS-232C I/F circuit board assembly to the connector plate, and tighten the two
screws.
49. Attach the parallel I/F circuit board assembly to the connector plate, and tighten the two
screws.
50. Attach the RS-232C I/F circuit board assembly or the parallel I/F circuit board assembly to
the main circuit board unit with two screws.
51. Attach the lower plate and the IC cover to the main unit sub assembly plate A with five
screws. Align the lower plate with the nibs on the main unit sub assembly and insert. Insert
the IC cover into the lower plate and tighten the screws. After that, tighten the screws at
four positions on the lower plate.
52. Tighten three label.
53. Affix a caution seal.
54. Affix an operation label (type CA).
55. Affix an operation label (type BA).
56. Affix an operation label (type DA).
Disassembly and Assembly 2-38 Rev. A