Epson TM-H6000 Service Manual page 33

Confidential
Pre-assembly of the Slip T. O. F Detector Assembly
1. Solder lead wires I, J, K to the slip T. O. F detector assembly.
Note:
Check that the soldering is secure.
Pre-assembly of the Lever motor T. P. Detector Assembly
1. Solder lead wires F, G, H to the lever motor timing pulse (T. P.) detector assembly.
Note:
Check that the soldering is secure.
Pre-assembly of the Carriage Frame Unit
1. Lubricate in five places. See Appendix G for 2 lubrication diagram.
2. Insert the ribbon feed spring into the ribbon take-up gear shaft. Position the ribbon feed
spring tooth so that it is facing upward, and insert the ribbon feed spring all the way by
rotating it to the right.
3. Lubricate the ribbon feed spring surface. See Appendix G for a lubrication diagram.
4. Fasten the ribbon take-up gear assembly to the carriage frame assembly. Position and insert
the ribbon feed spring tooth and the ribbon take-up gear assembly notch.
5. Attach the carriage transmission pulley to the carriage transmission pulley shaft.
6. Lubricate in one place. See Appendix G for a lubricationdiagram.
7. Attach the belt drive cap. Insert the belt drive cap surface so that it is facing upward to
install it.
8. Insert the carriage drive transmission gear onto the transmission gear shaft.
Disassembly and Assembly 2-4
671 Slip T.O.F. detector assembly
713 Lead wire (type I)
714 Lead wire (type J)
715 Lead wire (type K)
Figure 2-3
672 Lever motor T.P.
detector assembly
710 Lead wire (type F)
711 Lead wire (type G)
712 Lead wire (type H)
Figure 2-4
Rev. A