Epson TM-H6000 Service Manual page 47

Confidential
48. Apply oil to the Platen lever drive cam shaft.
screw(C.B.S-tite F,3X6)
E-ring(3)
691
screw(C.B.S-tite F,3X6)
609
Slip feed roller shaft
holder
645
Slip guide upper frame
727
Sub slip hold sleeve
648
Sub slip hold roller
612
Front frame
611
Front reinforcement frame
691
691
691
screw(C.B.S-tite F,3X6)
49. Attach the paper feed motor to the sub assembly frame and fix with two screws. Check that
the paper feed motor circuit board surface is facing the back of the mechanism.
50. Snap fit the TOF slip detector assembly to the slip guide upper frame.
51. Insert the lead wire.
52. Attach the motor lever T. P. detector assembly to the main sub assembly with one screw.
Turn over the main sub assembly frame and align the detector with the lever drive motor
detector plate in two places. Check that the lever drive motor detector plate and the detector
do not touch.
53. Using two screws, attach the main circuit board assembly (for M-U675) to the main sub
assembly frame. Place the side with the connector to the front of the main sub assembly
frame, and insert set so that the soldered side of the main circuit board assembly (for M-
U675) is up. Align with the nibs in two places.
54. Solder the lead wires of the cables.
Disassembly and Assembly 2-18
609 Slip feed roller shaft holder
691
686
691
654
Endorsement platen shutter
637
Slip hold roller shaft
686 E-ring(3)
727
Sub slip hold sleeve
Figure 2-15
686 E-ring(3)
615 Lever drive transmission gear
626 Platen lever drive cam
724 Slip hold roller spring
723 Slip hold roller sleeve
609 Slip feed roller shaft holder
686
638
609
639
686
639
638
638
686
609 Slip feed roller shaft holder
634 Paper feed transmission gear
638 Slip transmission gear
639 Slip drive gear
686 E-ring(3)
689 E-ring(2.3)
692 J/S change gear
634
686
647
692
689
693 686
Rev. A