Epson TM-H6000 Service Manual page 43

Confidential
9. Insert the crank shaft holder from the left and right outer sides attach with one E-ring.
665
Lever drive shaft
assembly
10. Press the lever drive shaft gear into the drive gear assembly lever.
11. Install the sub slip feed assembly roller into the main sub assembly set frame. Align the D-
cut side of the sub slip feed assembly roller with the left side of the frame and the the
opposite side of the shaft with the U groove.
12. Press in the slip drive gear onto the sub slip feed assembly roller. Press in starting from the
slip drive gear whose diameter is larger. (see the illustration on the next page.)
13. Snap fit the lever drive motor detector plate to the lever drive motor gear.
Disassembly and Assembly 2-14
screw(C.C.S-tite,2.5X5)
729
screw(C.B.,2.6X4)
618
Form stopper shaft
694
Crank shaft
holder
691 screw(C.B.S-tite F,3X6)
690
636 Sub slip feed lever shaft
Figure 2-13
619
Form stopper spring
684
E-ring(1.5)
617
Form stopper
644
Sub slip feed roller holder
641
Sub slip feed lever spring
659
Lever drive motor assembly
705
Lead wire (type A)
706
Lead wire
(type B)
688 E-ring(5)
694 Crank shaft holder
691 screw(C.B.S-tite F,3X6)
Rev. A